Contact
Skin contact and daily wear ask for hand, surface, and care, not a single mass figure. A cotton elastane jersey can feel different from a synthetic stretch warp knit at the same nominal GSM because the fiber share, the stitch, and the finish all change the surface. Natural-fiber arguments start with hand, moisture, and the care the wearer will use. Synthetic-fiber arguments start with tensile strength, drying, and the finish that can be applied. Neither side is an environmental ranking. Write the care the garment will actually receive: a gentle home wash, a high-heat dryer, or a commercial laundry cycle. Colorfastness and pilling, if they matter, need their own methods and end points. A soft hand is not proof of abrasion resistance, and a durable surface is not proof that the cloth will feel acceptable in the pattern. Keep a dated cutting so later shade or hand comments refer to the same face. This column is a way to describe the use. It is not a record of a finished programme or a wearer trial already completed for this site.
Exposure
Moisture questions should be split before anyone borrows a number. Sweat next to skin, a rain shell, and pool water are different exposures. For stretch apparel, the usual issues are how the cloth recovers after being wet, how the shade holds, and whether chlorine or salt water is even relevant. Nylon lycra swimwear fabric talk belongs here only as a fabric question: knit type, elastane share, and the exposure you need to discuss. It is not a finished swimsuit offer. Liquid water resistance and water vapor transmission describe other behaviors and should not be pasted onto a stretch jersey without a method and a specimen. Hydrostatic head belongs with coated cloth, not with an uncoated jersey. If you have a report, name the standard, the conditioning, and the finish state, for example ISO 105 for colorfastness or ASTM D2594 for knit stretch recovery. Results from a different construction do not travel with the fiber name. Weathering and light exposure, when they matter, also need their own specimen notes.
Processing
Cutting and joining decide whether a stretch cloth can be used, even when the fiber story looks right. State the usable width the marker needs and keep it separate from the full cloth width and the selvedge. Note the stretch direction the pattern consumes, because a course-stretch knit and a bias cut do not feed a marker the same way. Seam slippage, needle cutting, and cover-stitch behavior are assembly questions. They are not answered by denier alone. Heat-setting and dyeing can change both width and stretch recovery, so the sample state should match the finish you intend to approve. Yarn supply and cloth supply are different formats: a cone, a roll, or a cut length. A stock selection has to confirm the batch on hand and whether another lot can follow it. A custom development has to name the sample, the trial, and the bulk approval point before anyone treats the route as approved. Name the format that applies and leave stock and lead time for the inquiry. Nothing on this page sets a minimum or a ship date.